Philips FX10/37 User manual - Page 19

English 9 Other features Set the alarm timer This unit can be used as an alarm clock.You can select disc, radio or USB as alarm source. 1 Make sure that you have set the clock correctly. 2 Press and hold SLEEP/TIMER for more than two seconds. »» 'TIMER SET' is displayed.Then, a prompt to select the sound source is displayed. 3 Press SOURCE to select a source from DISC, USB and FM, then press SLEEP/ TIMER to confirm. »» The hour digits are displayed and begin to blink. 4 Press / repeatedly to set the hour, then press SLEEP/TIMER to confirm. »» The minute digits are displayed and begin to blink. 5 Press / repeatedly to set the minute, then press SLEEP/TIMER to confirm. »» A prompt to select the volume level is displayed. 6 Press +/- to select the desired volume level, then press SLEEP/TIMER to confirm. »» The alarm timer is set and activated. To deactivate or re-activate an alarm timer • In standby mode, press SLEEP/TIMER repeatedly. »» When the alarm timer is deactivated, ''TIMER OFF is displayed. »» When the alarm timer is re-activated, 'TIMER ON' is displayed. Tip •• In BT, AUDIO IN or AUX IN mode, the alarm timer cannot be set. •• If the disc or USB source is selected but no audio file can be played, FM radio is activated automatically. Set the sleep timer This unit can switch to standby automatically after a set period of time. • When the unit is turned on, press SLEEP/ TIMER repeatedly to select a set period of time (in minutes). To deactivate sleep timer • Press SLEEP/TIMER repeatedly until [OFF] (off) is displayed. Restore default settings You can also restore the default settings of the unit. • In any mode, press and hold on the front panel for more than five seconds. »» After a while,'RESET OK' is displayed. Then, the device reboots automatically. EN 17