Philips MCD703 User manual - Page 31

Other Functions English Radio Reception Tuning to radio stations 1 Press ECO POWER/STANDBY-ONy (or y on the remote) to switch on the last selected source. 2 Press SOURCE (or TUNER on the remote) to select TUNER mode. 3 Press BAND/9 (or TUNER on the remote) again to select the desired band: FM or AM. 4 Press and hold the control knob to the left/right (corresponding to S/T) or TU +/- à/ á on the remote until the frequency indication starts to change, then release. ➜ The system automatically tunes to the next strong radio station. ● To tune to a weak station, press the control knob to the left/right (corresponding to S/ T) or TU +/- à/ á on the remote briefly and repeatedly until an optimal reception is found. 5 Repeat Step 4 if necessary until you find the desired radio station. Presetting radio stations You can preset up to 40 stations (20 in each band) regardless of the reception. 1 Tune to your desired radio station (refer to "Tuning to radio stations"). 2 Press the control knob upward (corresponding to PROGRAM) or press PROG on the remote. ➜ "PROG" icon flashes. 3 Press CH on the remote to select the desired preset number. ➜ If "PROG" icon goes off before you select the desired preset number, press the control knob upward (corresponding to PROGRAM) or press PROG on the remote. 4 Press the control knob upward (corresponding to PROGRAM) or press PROG on the remote again to store the radio station. ● Repeat steps 1-4 to store other radio stations. Listening to preset radio stations ● In tuner mode, press PRESET/ÉÅ(or CH on the remote) or use the Numeric Keypad (0-9) to select the desired preset number. ➜ The preset number, radio frequency, and waveband are displayed. Setting the clock 1 In Standby mode, press and hold CLOCK on the remote until the time flashes on the display. ➜ "CLOCK SET" is displayed briefly.Then, the hour digits flash on the display screen. 2 Turn VOLUME -/+ clockwise or anticlockwise or press VOLUME +/- on the remote to set the hours. 3 Press CLOCK to confirm. ➜ The minute digits flash on the display screen. 4 Turn VOLUME -/+ clockwise or anticlockwise or press VOLUME +/- on the remote to set the minutes. 5 Press CLOCK again to confirm the clock setting. Notes: - This system only supports 24-hour mode. - The clock setting will be erased when the system is disconnected from the power supply. - The system will exit clock setting mode if no button is pressed within 30 seconds. Setting sleep/wake-up timer Sleep timer setting In power-on mode, the sleep setting enables the system to switch to standby mode automatically at a preset time. 1 In power-on mode, press SLEEP/TIMER on the remote repeatedly to select a preset time. ➜ The selections are as follows (time in minutes): 00 ➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70 ➜ 80 ➜ 90 ➜ 00 2 When you reach the desired length of time, stop pressing SLEEP/TIMER. ➜ "SLEEP" appears. 31