Philips MX980D User manual (English) - Page 15
Subwoofer Mx 960d, Mx 980d Only
View all Philips MX980D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English SUBWOOFER (MX 960D, MX 980D only) 0 9 8 7 6 5 L + IN + AC ~MAINS SPEAKER R L + OUT + R L - R L - R SSEOLEUCRTCOER SSPUEBAWKOEROFINER/ IWNIRELESS SUBWOOFER IN PHASE SELECTOR 0° 180° 1 2 STANDBY - ON SUBWOOFER LEVEL CONTROL CUT OFF FREQUENCY 60 Hz 150 Hz MIN HIGH POWER SUBWOOFER MAX 3 4 Controls 1 STANDBY-ON y Switches the subwoofer on and to standby. 2 Status light. 3 CUT OFF FREQUENCY...Adjusts the frequency range reproduced by the subwoofer. 4 SUBWOOFER LEVEL CONTROL Adjusts the volume of the subwoofer. Connectors 5 PHASE SELECTOR.........Selects the best bass reproduction. 6 SUBWOOFER IN Connect to SUBWOOFER PRE-OUT at the receiver. 7 SOURCE SELECTOR ......Selects the used signal input. Keep at the SUBWOOFER IN position if the receiver is connected as described below. 8 AC MAINS After all other connections have been made, connect the power cord to AC MAINS and to the power outlet. 9 SPEAKER OUT Not used with the receiver supplied. 0 SPEAKER IN Not used with the receiver supplied. The type plate is located on the rear of the subwoofer. Connections 1 Use the cinch cable supplied to connect SUBWOOFER IN to SUBWOOFER PRE-OUT at the receiver. 2 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organization. 3 Connect the power cable to the power outlet. This switches on the power supply. Do not connect the subwoofer to the outlets of the receiver. Note: To disconnect completely the subwoofer from the power, remove the power plug from the power outlet. Adjustment The subwoofer must be adjusted to your listening environment and to your speaker setup. This only needs to be done once. 1 Press y to switch on the subwoofer. yThe status light turns green. 2 Play one of your favorite tracks at a normal listening level. 3 Turn SUBWOOFER LEVEL CONTROL to adjust the volume of the subwoofer. 4 Select the reproduced frequency range by turning CUT OFF FREQUENCY. The higher the cut off frequency is set, the stronger the bass reproduction will be. Note: The subwoofer reproduces the range between 35 Hz and the frequency selected with CUT OFF FREQUENCY. 5 You may switch PHASE SELECTOR from 0° to 180°. Select the setting that provides the sound that produces the bass effect. 6 Press y to switch the subwoofer to standby. yThe status light turns red. Operation 1 Press y to switch on the subwoofer. yThe status light turns green. 2 If the sound reproduction is noisy, reduce the volume of the subwoofer. 3 Press y to switch the subwoofer to standby. yThe status light turns red. 15