Pioneer AVIC N2 Installation Manual - Page 16

How to Use Navigation Unit and Names of the Parts Chapter 1 ❒ If the DVD drive does not operate properly, an error message such as ERROR-11 may be displayed. ➲ Error messages ➞ Operation Manual ❒ When a CD or CD-ROM is inserted, sound only is output to the rear display. ➲ Selecting the video of rear display ➞ Operation Manual Adjusting the volume • Use VOLUME to adjust the audio sound level. With this product, rotate VOLUME to increase or decrease the volume. Please refer to save volume level instructions on page 1 of this manual. ❒ To adjust the navigation volume, go to the navigation menu. ➲ Navigation volume adjustment ➞ Operation Manual Turning the source off • Press SRC button and hold until the source turns off. ❒ This product can be switched off by turning the ACC (ignition) OFF or detaching the front panel. Using the REAR button You can output the sound and video of the disc in the built-in DVD drive to the rear display regardless of whether DVD drive is selected as the source or not (REAR ON mode). • When you have turned the REAR ON mode on by pressing REAR button, you cannot turn it off even if you press SRC button and hold. In this case, press REAR button to turn the REAR ON mode off. • Press REAR button to turn the REAR ON mode. The sound and video are outputted to the rear display and the illumination color of REAR button changes to red. ❒ To turn the REAR ON mode off, press REAR button again. Opening and closing the LCD panel • Do not close the LCD panel with hands by force. This may cause malfunction. The LCD panel will be opened or closed automatically with the turning of the ignition switch on or off. You can turn off the automatic close/open function. ➲ Setting the automatic close/open function ➞ Operation Manual • The automatic close/open function will operate the display as follows. - When the ignition switch is turned OFF while the LCD panel is open, the LCD panel will close after six seconds. - When the ignition switch is turned ON again (or turned to ACC), the LCD panel will open automatically. - Removing or attaching the front panel will automatically close or open the LCD panel. ➲ Removing the front panel ➞ Page 17 • When the ignition switch is turned OFF after the LCD panel has been closed, turning the ignition switch ON again (or turning it to ACC) will not open the LCD panel. In this case, press OPEN/CLOSE button to open the LCD panel. • When closing the LCD panel, check to make sure that it has closed completely. If the LCD panel has stopped halfway, leaving it like this could result in damage. • Press OPEN/CLOSE button to open the LCD panel. ❒ To close the LCD panel, press OPEN/ CLOSE button again. 14