Pioneer CDS-P4000 Operation Manual - Page 2
Display Modes, Using the CD Player, Before Using This Product
View all Pioneer CDS-P4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Before Using This Product About This Manual Operate this CD Player with a Head Unit connected. For details concerning operation, refer to the back page of this manual. Important The serial number of this device is located on the bottom of this product. For your own security and convenience, be sure to record this number on the enclosed warranty card. Resetting the Microprocessor The microprocessor must be reset under the following conditions: When using this product for the first time after installation. When the machine fails to operate properly. When strange (incorrect) messages appear on the display. • To reset the microprocessor, press the RESET button with a pen tip or other pointed instrument. Precaution CAUTION: CAUTION: USE OF CONTROL OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. • Keep this manual handy as a reference for operating procedures and precautions. • Protect the product from moisture. After-sales Service for Pioneer Products Please contact the dealer or distributor from where you purchased the product for its aftersales service (including warranty conditions) or any other information. In case the necessary information is not available, please contact the companies listed below: Please do not ship your product to the companies at the addresses listed below for repair without advance contact. 7 U.S.A. Pioneer Electronics Service, Inc. CUSTOMER SERVICE DEPARTMENT P.O. Box 1760 Long Beach, CA 90801 800-421-1404 7 CANADA Pioneer Electronics of Canada, Inc. CUSTOMER SATISFACTION DEPARTMENT 300 Allstate Parkway Markham, Ontario L3R OP2 (905) 479-4411 1-877-283-5901 For warranty information please see the Limited Warranty sheet included with your product. Using the CD Player Playing the CD Player The CD player plays one standard 12 cm or 8 cm CD at a time. Do not use any adapter when playing a 8 cm CD. 1. Insert the disc with the label side up. Lights up when a CD is loaded. Lights up when a CD is playing. 2. For details concerning operation, refer to the back page of this manual. 3. Remove the disc. Note: • A disc left partially inserted after ejection may incur damage or fall out. • If a disc cannot be inserted fully or playback fails, make sure the recorded side is down. Press the EJECT button and check the disc for damage before reinserting it. • If a CD is inserted with the recorded side up, it will be ejected automatically after a few moments. • If the CD player cannot operate properly, an error message (such as "ERROR-14") appears on the head unit display. Refer to "CD Player Troubleshooting". • Do not insert anything other than a CD into the CD Loading Slot. Display Modes Level Indicator Display This product has eight display patterns (Mode 1 to Mode 8) from which you can choose one at a time. • Selecting the Level Indicator display. Each press changes the Display ... Each press of the DISPLAY button changes the display in the following order: Mode 1 Ô Mode 2 Ô Mode 3 Ô Mode 4 Ô Mode 5 Ô Mode 6 Ô Mode 7 Ô Mode 8 Ô Mode 1 ... Mode 1, Mode 2, Mode 3 and Mode 4 Segments light from left to right according to the audio level. Example: Mode 1 Mode 5 Segments light from the center, and expand towards the sides according to the audio level. Example: Mode 5 Mode 6 Display shows segments rotating from left to right. Example: Mode 6 Mode 7 Depending on the audio level, different segments light up. Example: Mode 7 Mode 8 Display turns off except for the "DISC SET" and "PLAY" indications. Example: Mode 8