Pioneer CNSD-130FM Upgrade Guide - Page 23

Troubleshooting Appendix Problems in the procedures for updating Symptom Cause Action The upgrade process doesn't An incorrect SD memory card has start and the navigation system been inserted. boots up as usual. Upgrade has been already done. Eject the inserted SD memory card and insert the correct upgrade SD memory card. Check whether the upgrade was done properly. If the upgrade has not been done yet, consult the nearest authorised service station. The screen that cannot begin the upgrade process is displayed. Eject the upgrade SD memory card, and display the map of your current position, and then reinsert the card. The navigation system does not work properly after upgrade. The engine of your vehicle was stopped or the power supply to the navigation system was turned off during upgrade process. Consult the nearest authorised service station. Upgrade SD memory card was Consult the nearest authorised service sta- pulled out during upgrade process. tion. Troubleshooting Messages in the procedures for updating The following messages may be displayed by your navigation system. Refer to the table below to identify the problem, then take the suggested corrective action. There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display. Message When An error occurred and the up- Unexpected error occurred in the date failed. update process. What to do Consult your local Pioneer dealer if this message persist. Engb 23