Poulan 271190 User Manual - Page 8
HOW TO SET UP YOUR TRACTOR, TO ROLL TRACTOR OFF SKID, Operation for location and, function
View all Poulan 271190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
HOW TO SET UP YOUR TRACTOR INSTALL SEAT Adjust seat before tightening adjustment knob. 1. Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. 2. Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard. 3. Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan. 4. Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor. 5. Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten. 6. Lower seat into operating position and sit in seat. 7. Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. 8. Get off seat without moving its adjusted position. 9. Raise seat and tighten adjustment knob securely. Seat pan Label Terminal Terminal 02602 NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls) 1. Press lift lever plunger and raise attachment lift lever to its highest position. 2. Release parking brake by depressing clutch/brake pedal. 3. Place gearshift lever in neutral (N) position. 4. Roll tractor forward off skid. 5. Remove banding holding deflector shield up against tractor. TO DRIVE TRACTOR OFF SKID (See Seat Shoulder Operation section for location and Bolt function of controls) WARNING: Before starting, read, un- Seat Pan derstand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other 2466 people and objects. 1. Be sure all the above assembly steps Flat Washer have been completed. 2. Check engine oil level and fill fuel tank with gasoline. Adjustment 3. Sit on seat in operating position, Knob 02464 depress clutch/brake pedal and set the parking brake. CHECK BATTERY 1. Lift seat pan to raised position. NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions). 4. Place gear shift lever in neutral (N) position. 5. Press lift lever plunger and raise attachment lift lever to its highest position. 6. Start the engine. After engine has started, move throttle control to idle position. 7. Depress clutch/brake pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear. 8. Slowly release clutch/brake pedal and slowly drive tractor off skid. 8