Poulan 271490 User Manual - Page 22
To Adjust Brake, To Replace Motion Drive Belt
View all Poulan 271490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
3. Roll belt off engine pulley. 4. Disconnect R.H. suspension arm from rear deck bracket by removing retainer spring. 5. Work belt off both mandrel pulleys and idler pulleys. 6. Pull belt away from mower. BELT INSTALLATION 1. Work new belt around both mandrel pulleys and idler pulleys. 2. Install new belt into engine pulley grove. 3. Reconnect R.H. suspension arm and secure with retainer spring. 4. Make sure belt is in all pulley grooves and inside all belt guides. Mandrel Pulley R.H. Suspension Arm 38 42 Retainer Spring 02373 Mandrel Pulley TO ADJUST BRAKE Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle. If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted. 1. Depress clutch/brake pedal and en- gage parking brake. 2. Measure distance between brake oper- ating arm and nut "A" on brake rod. 3. If distance is other than 1-1/2", loosen jam nut and turn nut "A" until distance becomes 1-1/2". Retighten jam nut against nut "A". 4. Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary. Contact an authorized service center/ department. With Parking Brake "Engaged" 1-1/2" Nut "A" Jam Nut Operating Arm 00238 TO REPLACE MOTION DRIVE BELT Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL 1. Remove mower (See "TO REMOVE MOWER" in this section of manual). NOTE: Observe entire motion drive belt and position of all belt guides and keepers. 2. Remove belt from stationary idler and clutching idler. 3. Remove belt downward from around engine pulley. 4. Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keepers. 5. Remove belt from center span keeper and pull belt away from tractor. BELT INSTALLATION 1. Carefully work new belt down between transaxle belt keepers and onto the input pulley. 2. Slide belt into the center span keeper. 3. Pull belt toward front of tractor and roll around the top groove of engine pulley. 4. Install belt through stationary idler and clutching idler. 5. Make sure belt is in all pulley grooves and inside all belt guides and keepers. 6. Install mower (See "TO INSTALL MOWER" in this section of manual). Engine Pulley Clutching Idler Stationary Idler Center Span Keeper Transaxle Pulley 22 00811