Poulan PP11530ES User Manual - Page 9
Meets A.n.s.i. Safety Requirements
View all Poulan PP11530ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
OPERATION SAFETY IGNITION KEY SPARK PLUG CHOKE CONTROL ENGINE OIL CAP AUGER DISCHARGE CHUTE CONTROL LEVER WITH DIPSTICK CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER GASOLINE FILLER CAP CHUTE DEFLECTOR TRACTION DRIVE CONTROL LEVER THROTTLE / ENGINE CONTROL OIL DRAIN PLUG DISCHARGE CHUTE RECOIL (AUXILIARY) STARTER HANDLE PRIMER POWER CORD PLUG ELECTRIC START BUTTON FUEL SHUT-OFF VALVE CLEAN-OUT TOOL LH TURN TRIGGER LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX DRIFT CUTTER SKID PLATE AUGERS FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-propelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. Auger control lever - used to engage auger motion (throw Recoil (auxiliary) starter handle - used for starting engine. snow). Drift cutter - used to cut through deep snowdrifts. Discharge chute control lever - used to change the direction the snow is thrown. Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Skid plate - used to adjust height of scraper bar from the ground. Choke control - used for starting a cold engine. Deflector remote control lever - used to change the LH and RH turn triggers - used to steer the snow thrower. 9 distance the snow is thrown.