Poulan PR111 Owner Manual - Page 14
Helpful Tips & Suggestions
View all Poulan PR111 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Helpful Tips & Suggestions STORING YOUR ENGINE Storage Preparation Proper storage preparation keeps your engine trouble-free and clean. The following steps will assist in keeping rust and corrosion from impairing your engine's function and appearance, and will make the engine easier to start when using again. Cleaning If the engine has been running, allow it to cool for at least half an hour before cleaning. Clean all exterior surfaces and apply a light film of spray penetrating lubricant. • Do not allow water to enter into the exhaust ports or into the heat shield openings (intake port). Water that passes through these areas can cause damage to the engine. Use a rag to wipe down heat shield if cleaning is required. • Water contacting a hot engine can cause damage. If the engine has been running, allow it to cool for at least half an hour before cleaning. • It's best to use compressed air to clean debris from engine. Adding a Fuel Stabilizer to Extend Fuel Storage Life • NOTICE Fuel stabilizer is recommended for long term storage. 1. Turn the red fuel knob to the OFF position while engine is running and allow the engine to run until it stops. Turn engine OFF when it begins surging to avoid engine damage. 2. Add fuel stabilizer, following the manufacturer's instructions. 3. Turn the red fuel knob to the ON position after adding fuel stabilizer. 4. Re-start engine. 5. Run the engine outdoors for 1 minute to be sure that treated gasoline has replaced the untreated gasoline in the carburetor. 6. Slow the engine to an idle speed. 7. Repeat step 1 above. MAINTENANCE SCHEDULE Normal Operating Conditions (less than 40 hrs. per year) Engine Oil Level Engine Oil Spark Plug* Cylinder/Head Fins Oil Leaks Bolts Fuel Hose Clamps EACH USE Check Check/Repair Check/Repair Check/Repair * Spark plug gap to be set to 0.027 - 0.030 inches. FIRST MONTH Replace EVERY 6 MONTHS Replace Clean ONCE A YEAR Replace Clean Extreme Operating Conditions (greater than 40 hrs. per year) Engine Oil Level Engine Oil Spark Plug* Cylinder/Head Fins Oil Leaks Bolts Fuel Hose Clamps EACH USE Check Check Check/Repair Check/Repair Check/Repair * Spark plug gap to be set to 0.027 - 0.030 inches. rev. 01/04/16 EVERY 40 HOURS Drain and Replace Replace Clean CAUTION Following proper maintenance is critical under extreme operating conditions. Snow Engine Manual 11