ProForm 1200 Pro Elliptical English Manual - Page 7
Tip: Do not pinch the Upper Wire Harness
View all ProForm 1200 Pro Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Tip: Do not pinch the Wire Harnesses (97, 3 54) during this step. Start all screws before tightening any of them. While another person holds the Upright (6) near the Frame (1), connect the Upper Wire Harness (97) to the Lower Wire Harness (54). Attach the Upright (6) to the Frame (1) with five 5/16" x 1" Patch Screws (81) and five 5/16" Split Washers (105). 6 81 105 81 Do not pinch the Wire Harnesses (97, 54) during this step 97 54 1 105 81 4. Apply a generous amount of the included grease to the Pivot Axle (33) and to two 5/8" Wave Washers (102). 4 104 97 81 Tip: Do not pinch the Upper Wire Harness (97). Insert the Pivot Axle (33) into the Upright (6). Then, slide a 5/8" Wave Washer (102) onto each end of the Pivot Axle. 94 102 Grease Next, orient an Upper Body Arm (12) so that the 5/16" x 78mm Shoulder Patch Screw (71) in the lower end is facing away from the Upright (6). 12 6 Slide the Upper Body Arm (12) onto the Pivot Axle (33). Attach the Upper Body Arm with a 71 5/16" x 1" Patch Screw (81), an Outer Large Axle Cover (94), and a 5/16" Washer (104). Attach the other Upper Body Arm (12) in the same way. Grease 33 102 104 94 81 12 71 7