ProForm 1500 Rt Treadmill English Manual - Page 11

9. Set the console assembly face down on a soft surface to avoid scratching the console. 9 Identify the Right Handrail (79). Remove the tie from the bracket on the Right Handrail. If necessary, press the U-nut (27) back into place. 79 8 Console Wire 12 Tie 27 4 Hold the Right Handrail (79) near the console 9 assembly. Route the console wire through the large holes in the top and bottom of the Right Handrail. Console Set the Right Handrail (79) on the Console Assembly Frame (81). Start a 1/4" x 1/2" Patch Bolt (8) 81 with a 1/4" Star Washer (12) into the Right Handrail. Then, start two 5/16" x 1 1/2" Patch Bolts (4) with two 5/16" Star Washers (9) into the Right Handrail. Make sure that the console wire is not pinched. Do not tighten the Patch Bolts yet. Attach the Left Handrail (not shown) as described above. Note: There is not a wire on the left side. 10. With the help of a second person, hold the console assembly near the Right Upright (83) and the Left Upright (not shown). Connect the Upright Wire (85) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire (85). 10 Console Assembly Console Wire 85 Wire Tie 83 Console Wire 85 11