ProForm 285t English Manual - Page 6

3. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [14] in 3 the direction shown by the arrow as you insert the Extension Leg.) Make sure that the Base Pad (36) is on the indicated side of the Extension Leg. Attach the Extension Leg with an Extension Leg Screw (34). Be sure to push on the head of the Extension Leg Screw while tightening it. Next, attach the other Extension Leg (41) (not shown) in the same way. 4. Slide a Rubber Ring (74) onto the post on each Upright (14). Refer to the inset drawing. Make sure that each Rubber Ring is turned so the tapered edge is toward the thickest part of the post. 4 Post 14 74 Tapered Edge 14 34 41 36 Post 74 14 5. Slide the upper end of one of the Handrails (2) onto the post on one of the Uprights (14). Push the Handrail as far forward as possible. Loosely thread a Handrail Screw (13) into the Handrail. Next, align the lower end of the Handrail with the hole in the Upright. Loosely thread a Handrail Bolt (15) with a Handrail Washer (16) into the Handrail and the Upright. Attach the other Handrail (2) as described above. Tighten the Handrail Screws (13) and the Handrail Bolts (15). 6. Attach the Storage Latch (12) to the left Upright (14) with two Latch Screws (13). Be careful not to overtighten the Latch Screws. 7. Make sure that all parts are tightened before you use the treadmill. (Note: The ratchet screws shown at the far right are factory set and should not be adjusted.) Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat under the treadmill. 5 14 13 13 2 14 2 15 16 6 15 16 14 Ratchet Screws 13 12 6