ProForm 3.9 Uk Manual - Page 12
Press the Latch Sleeve 30 into the Left Upright
View all ProForm 3.9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
14. Attach the ground wire on the Upright Wire (28) to the indicated hole in the Base (48) with an M4.2 x 10mm Screw (11). Then, press the indicated Grommet (54) into the Right Upright (36). Attach the Right Base Cover (91) to the Base (48) with two 3/4" Screws (2). Note: Start both 3/4" Screws before tightening them. Attach the Left Base Cover (not shown) in the same way. Raise the Uprights (31, 36) to a vertical position. 14 2 48 Hole Ground Wire 54 28 36 11 2 91 15. Press the Latch Sleeve (30) into the Left Upright (31). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Insert the pin into the Latch Sleeve (30) and the Left Upright (31). Press the Latch Insert (89) into the other side of the Left Upright, and then tighten the knob back onto the pin. Remove the plastic packaging from the bottom of the treadmill. 15 Knob 89 31 30 Spring Collar Pin 16. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill. 12