ProForm 4.0 User Manual - Page 10

11. Set the Pulse Bar Bottom (95) on the Left 11 Handrail (35) and the Right Handrail (33). Press the Pulse Bar Bottom forward as you tighten two #10 x 3/4" Screws (5) with two #10 Star Washers (10) into the Handrails. Remove the long tie from the Upright Wire (38). 35 10 5 Long Tie 5 38 95 10 33 12. With the help of a second person, hold the console assembly near the Right Handrail (33) and the Left Handrail (not shown). Connect the Upright Wire (38) to the Console Wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and the excess wire into the Right Handrail (33). 12 33 Console Wire 38 Console Assembly Console Wire 38 13. Connect the console ground wire to the handrail ground wire. Set the console assembly on the Right Handrail (33) and Left Handrail (35). Make sure that the wire harnesses are not pinched. Attach the console assembly with two #8 x 1/2" Screws (1), four #8 x 3/4" Screws (12), and four #8 x 1/2" Washer Head Screws (112). Start all the Screws before tightening any of them. Cut the plastic tie from the Right Handrail (33). See steps 5 and 7. Firmly tighten the four 3/8" x 4" Bolts (6). 13 Console Assembly Ground Wires Plastic 112 Tie 12 1 33 12 35 12 112 10