ProForm 470 English Manual - Page 6
Attach the Left Pedal 8 to the Left Pedal Tube
View all ProForm 470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
4. The Console (22) requires four "AA" batteries; alkaline batteries are recommended. Remove the bat- 4 tery cover from the back of the Console and insert four batteries into the Console; make sure that the batteries are oriented as shown by the diagram inside the Console. Then, reattach the battery 22 cover. Battery Cover Batteries 5. While another person holds the Console (22) near 5 the top of the Upright (3), connect the console wire 22 to the Upper Wire (75). Then, connect the lower wire on the back of the console to the upper wire on the back of the console. Attach the Console (22) to the Upright (3) with four 75 Console Screws (68). Be careful to avoid pinch- ing the wires. Note: If you have purchased the optional pulse sensor (see page 19 for more information), disregard the instructions for installing the receiver. The console on this elliptical exerciser already has a receiver installed. Console Wire Avoid pinching the wires during this step 68 3 6. Identify the Right Pedal (63), which has an "R" 6 molded into its bottom surface, and the Right Pedal Tube (64), which is marked with a sticker. 41 Attach the Right Pedal (63) to the Right Pedal Tube (64) with two M8 x 1 9/16" Hex Bolts (41), two M8 Washers (52), and two M8 Nylon Locknuts (57). 8 4 Attach the Left Pedal (8) to the Left Pedal Tube (4) in the same way. 63 64 52 52 57 6