ProForm 485 E English Manual - Page 7

3. Find the Left Pedal (31), which has a ridge on the 3 right side. Attach the Left Pedal to one of the Pedal Arms (12) with three #8 x 3/4Ó Round Head Screws (16) as shown. Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown). Ridge 31 12 16 4. Make sure that there are two Pedal Arm Bushings (42) in each Pedal Arm (12). Apply some of the included grease to the axles in the locations indicated. Slide a Handlebar Spacer (39) and the Pedal Arm (12) with the Left Pedal (31) onto a Handlebar (8) as shown. (Note: These parts fit tightly; it may be helpful to use the rubber mallet). Refer to the PART IDENTIFICATION CHART on page 5 and identify the 3/4Ó Axle Caps (43). Tap a 3/4Ó Axle Cap onto the Handlebar. Repeat this step to attach the other Pedal Arm (12) to the other Handlebar (8). 4 8 39 42 43 12 31 5. Make sure that there are two Rear Pedal Arm Bushings (11) in each Pedal Arm (12). 5 Slide a Pedal Arm Spacer (41) and the left Pedal Arm (12) onto the left Crank Arm (59) (these parts fit tight- ly; it may be helpful to use the rubber mallet). Be careful not to confuse the left Pedal Arm with the right Pedal Arm (not shown); look at the position 8 of the left Handlebar (8) to identify the left Pedal Arm. Tap a 3/4Ó Axle Cap (43) onto the left Crank Arm (59). Repeat this step to attach the right Pedal Arm (not shown). 8 12 Grease 59 41 11 12 43 7