ProForm 500 Cx Treadmill Uk Manual - Page 13
The Information Mode
View all ProForm 500 Cx Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
The lower right corner of the display will show the distance that you have walked or run, the elapsed time, your pace (in minutes per mile), and the speed of the walking belt. Note: When a program is selected (except for pulse program 2), the lower right corner of the display will show the time remaining in the program instead of the elapsed time. The center of the display is the priority display. Press the Display (DISP.) button repeatedly until the priority display shows the information that you most want to view. Note: While information is displayed in the priority display, the same information will not be displayed in the lower left or right corner of the display. Note: The console can display speed and distance in either kilometers or miles. A "Km/H" will appear in the right side of the display when the console is displaying speed and distance in kilometers. To change the unit of measurement, see THE INFORMATION MODE on page 23. Note: For simplicity, all instructions in this section refer to kilometers. To reset the display, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate if desired. Note: If you use the handgrip pulse sensor and the chest pulse sensor at the same time, the console will not Contacts display your heart rate accurately. Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. Next, hold the handgrip pulse sensor with your palms resting on the metal contacts; avoid moving your hands. When your pulse is detected, the heart symbol in the lower left corner of the display will appear, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 Turn on the fan if desired. To turn on the fan, press the Fan button. To turn on the fan at high speed, press the button a second time. To turn off the fan, press the button a third time. Note: If the fan is left on when the walking belt is stopped, the fan will automatically turn off after a few minutes. 8 When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the display remains lit after the key is removed, the console is in the "demo" mode. See page 23 and turn off the demo mode. When you are finished using the treadmill, switch the on/off switch to the "off" position and unplug the power cord. 13