ProForm 530 Zlt Instruction Manual - Page 9

4. Lay the Right Upright (76) near the Base (74) as shown. Attach the ground wire to the Base with a 4 #8 x 1/2" Ground Screw (1). Then, press the Upright Grommet (73) into the square hole in the Right Upright (76). 74 1 76 5. Hold the Right Upright (76) against the Base (74). Be careful not to pinch the Upright 5 Wire (63).  Insert a 3/8" x 3 1/4" Screw (2) with a 3/8" Star Washer (3) into the top hole in the Right Upright (76). Then, partially tighten the Screw into the Base (74). Partially tighten two more 3/8" x 3 1/4" Screws (2) with two 3/8" Star Washers (3) into the Right Upright (76) and the Base (74). Do not fully tighten the Screws yet. Attach the Left Upright (not shown) in the same way. Note: There are no wires on the left side. Ground Wire 73 Square Hole 76 63 74 3 2 3 9