ProForm 540 English Manual - Page 9

7. Set the Console (91) face-down on a soft sur- 7 face to avoid scratching the Console. Hold the Console Right Handrail (33), which has a large hole in the indicated location, near the Console. Next, insert the console wire into the hole in the Wire 85 Tie Bracket 7 10 side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail. 33 Large Next, set the Right Handrail (33) on the Console Hole (91). Make sure that no wires are pinched. Start a Crossbar Screw (85) with a Crossbar 91 Star Washer (7) into the Right Handrail, and then start two Console Screws (10) into the Right Handrail. Tighten the Crossbar Screw and then tighten the two Console Screws; do not overtighten the Screws. Attach the Left Handrail (not shown) to the Console (91) in the same way. Note: There are no wires on the left side. 8. See drawing 8a. If there is a guard on the end of 8 the Console Wire, press the indicated tab and re- move the guard with needlenose pliers. Discard the guard. With the help of a second person, hold the Console (91) near the Right Upright (54). Remove the strap from the Wire Harness (39). Connect the Wire Harness to the console wire. Make sure to connect the connectors properly (see drawing 8b). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and the excess wire into the Right Upright (54). 8a Console Wire Tab 91 Guard Console Wire 8b 39 54 39 9. Attach the Console (91) to the Right Upright (54) 9 and the Left Upright (53) with six Handrail Bolts (8) and six Handrail Star Washers (5). Make sure that no wires are pinched. Start all six Handrail Bolts and then tighten them. With the help of a second person, carefully lower the Uprights (53, 54) to the floor. 8 5 58 54 91 5 8 5 8 53 9