ProForm 560hr Treadmill Uk Manual - Page 9
If you purchase the optional chest pulse sensor see follow the steps below to install
View all ProForm 560hr Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screw (6) and the Access Door (94) from the back of the Console Back (95). 2. Remove the paper from the adhesive pad on the back of the receiver (A). Hold the receiver so the small cylinder is near the lower edge of the receiver and is facing the Console (88) as shown. Firmly press the receiver onto the indicated corner of the Access Door (94). Connect the wire on the receiver to the indicated wire extending from the Console. 3. Make sure that no wires are pinched. Reattach the Access Door (94) with the 3/4" Screw (6). The other wires included with the receiver may be discarded. A Wire Cylinder 95 88 Wire 94 6 9