ProForm 750 Cardio Cross Trainer English Manual - Page 6

2. While another person lifts the back of the Frame (1), attach the Rear Stabilizer (9) to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). 3. While another person holds the Upright (2) in the position shown, connect the Extension Wire Harness (44) to the Wire Harness (43). Carefully pull the upper end of the Extension Wire Harness to remove any slack. While holding the upper end of the Extension Wire Harness, slide the Upright onto the Frame (1). Do not pinch the Wire Harnesses. Secure the Upright (2) to the Frame (1) with two M10 x 74mm Button Bolts (7), two M10 Split Washers (59), and two M10 Nylon Locknuts (33). Do not tighten the Nylon Locknuts yet. 2 33 9 33 1 34 3 Make sure the Wire Harnesses 2 (44, 43) do not get pinched and damaged during this step. 59 33 7 59 44 43 1 4. Connect the wire harness on the Handgrip Pulse Sensor (29) to the indicated wire harness on the Console (23). Insert both wire harnesses into the opening in the bottom of the Console. Next, insert the metal tube on the Handgrip Pulse Sensor into the opening in the bottom of the Console. Be careful not to pinch the wire harnesses. Refer to the inset drawing. Align the holes in the bracket on the Console (23) with the holes in the metal tube on the Handgrip Pulse Sensor (29). Tighten two M4 x 16mm Screws (52) through the bracket into the tube as shown. 5. The Console (23) requires four "D" batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover, and lift off the battery cover. Insert four batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Reattach the battery cover. 4 52 23 29 23 Bracket Tube 52 Tube Wire Harnesses 5 Battery Cover 29 Tab Batteries 23 6