ProForm 750 Rx Elliptical Uk Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , an adjustable spanner , and a rubber mallet . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M8 Nylon Locknut (38)-4 M10 Nylon Locknut (33)-4 M10 Split Handlebar Washer (59)-6 Washer (55)-2 M10 Washer (78)-2 M4 x 16mm Screw (52)-2 M6 x 25mm Screw (7)-1 M8 x 19mm Button M10 x 27mm Screw (56)-2 Pedal Bolt (80)-2 Spring Bracket Washer (35)-2 M8 x 45mm Button Bolt (50)-4 M10 Bolt Set (74)-2 M10 x 27mm M10 x 27mm Patch Screw (40)-2 Button Screw (67)-6 M10 x 75mm Carriage Bolt (34)-4 1. Identify the Front Stabiliser (10), which has Wheels (22) attached to it. Whilst another person lifts the front of the Frame (1), attach the Front Stabiliser to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). Make sure that the Front Stabiliser is turned so the Wheels are not touching the floor. 1 22 34 22 34 10 1 33 5