ProForm 775treadmill English Manual - Page 11
setting. The incline must be at the lowest setting
View all ProForm 775treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
The right display-This display will show the distance that you have walked or run, the number of 1/4-mile laps you have completed, the speed of the walking belt, and the approximate numbers of calories and fat calories you have burned (see FAT BURNING on page 26). Note: When a program is selected, this display will show the time remaining in the program instead of the elapsed time. The right display will also show your heart rate when you use the handgrip pulse sensor or the optional chest pulse sensor. In addition, during heart rate programs the right display will show a heart rate bar that shows your heart rate as a percentage of your estimated maximum heart rate (see step 3 on page 14 for an explanation of your estimated maximum heart rate). For example, if four to six segments of the bar appear, your heart rate is between 60% and 70% of your estimated maximum heart rate. Heart Rate Bar Note: The console can display speed and distance in either miles or kilometers. The letters "MPH" or "Km/H" will appear in the right display to show which unit of measurement is selected. To change the unit of measurement, see THE INFORMATION MODE/DEMO MODE on page 21. To reset the displays, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate if desired. To use the handgrip pulse sensor, first make sure that your hands are clean. Next, stand on the foot rails and hold the pulse bar with your palms on the metal contacts. Avoid moving your hands. Contacts When your pulse is detected, the heart-shaped indicator in the right display will flash each time your heart beats, one or two dashes (- -) will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. Note: The pulse bar is intended to be used only for heart rate measurement. Do not use the pulse bar as a handlebar. Always hold the handrails for support when you are not measuring your heart rate. 7 Turn on the fan if desired. To turn on the fan, press the button below the fan. To turn on the fan at high speed, press the button a second time. To turn off the fan, press the button a third time. Note: A few minutes after the walking belt is stopped, the fan will automatically turn off. 8 When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the displays on the console remain lit after the key is removed, the console is in the "demo" mode. See page 21 and turn off the demo mode. When you are finished using the treadmill, switch the reset/off circuit breaker to the off position and unplug the power cord. 11