ProForm 920s Ekg English Manual - Page 12
Maintenance And Troubleshooting
View all ProForm 920s Ekg manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. Refer to assembly step 4 on page 5 for replacement instructions. Note: The console requires four "D" batteries. HOW TO LEVEL THE EXERCISE CYCLE After the exer- cise cycle has been moved to the location where it will be used, make sure that both ends of front stabilizer are touching the Leveling Foot floor. If the exer- cise cycle rocks slightly during use, turn one or both of the leveling feet under the front stabilizer until the rocking motion is eliminated. HANDGRIP PULSE SENSOR TROUBLE-SHOOTING • Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings. • Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. • For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. • For optimal performance of the handgrip pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth-never use alcohol, abrasives, or chemicals. HOW TO MOVE THE EXERCISE CYCLE To move the exercise cycle, first stand in front of the exercise cycle, hold the handlebars, and place one foot on the front stabilizer. Pull the handlebars until the exercise cycle can be moved on the front wheels. Carefully move the exercise cycle to the desired location and then lower it. Handlebars Place Foot Here Wheel 12