ProForm Crosstrainer 55 Bike English Manual - Page 6

5. Attach the Seat (12) to the Seat Frame (6) with three M6 x 16mm Screws (64). 5 12 6 64 6. Attach the Backrest (10) to the Backrest Frame (5) with two M6 x 16mm Screws (64), an M6 x 50mm Screw (69), and an M6 Flat Washer (71). 6 10 64 5 71 69 64 7. While another person holds the Upright (13) in the position shown, connect the Upper Wire Harness (35) to the Lower Wire Harness (36). Carefully pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses. Turn the Knob (not shown) on the right side of the Frame (1) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Upright (13) into the Frame, and then release the Knob. Move the Upright up and down slightly until it locks into position. Be careful to avoid pinching the Wire Harnesses (35, 36). Tighten the indicated M6 x 25.4mm Button Screw (79) into the slot in the Upright. 8. While another person holds the Console (16) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (35). Insert the excess wire harness into the Upright (13). Attach the Console (16) to the Upright (13) with four M4 x 16mm Screws (73). Be careful to avoid pinching the wire harnesses. Attach the Water Bottle Holder (89) to the Upright (13) with two M4 x 22mm Screws (91). 7 13 Slot 35 1 36 79 Knob 8 73 Wire 16 Harness 13 35 89 91 6