ProForm Gl125 Bike English Manual - Page 6
Attach the Right Inner Handlebar 68 to
View all ProForm Gl125 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. While another person holds the Upright (2) in the position shown, connect the Upper Wire Harness (42) to the Lower Wire Harness (43). Gently pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses. Turn the indicated Adjustment Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Upright (2) into the Frame (1), and then release the Knob. Be careful to avoid pinching the Wire Harnesses (42, 43). Move the Upright up and down slightly until the pin on the Knob snaps into one of the holes in the Upright. Then, turn the Knob clockwise until it is tight. Tighten the M6 x 25mm Button Screw (99) into the Frame. Attach the Water Bottle Holder (31) to the Upright (2) with two M4 x 12mm Screws (41). 2 Make sure the wire harnesses do not get pinched and damaged during this step. 2 20 1 42 43 99 31 41 3. Attach the Left Inner Handlebar (71) to the Upright (2) 3 with four M6 x 16mm Tapered Button Screws (102). 2 102 Attach the Right Inner Handlebar (68) to the Upright (2) in the same way. 102 68 71 4. Attach a Handlebar (3) to the Seat Bracket (11) with two M8 x 38mm Button Bolts (96) and two M8 Nylon 4 Locknuts (49). Make sure that the Nylon Locknuts are resting in the hexagonal holes in the front of the Handlebar. Attach the other Handlebar (3) to the Seat Bracket (11) in the same way. 3 3 11 49 96 6