ProForm Gl50 Bike English Manual - Page 4

ASSEMBLY Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable wrench . Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M6 Nylon Locknut (71)-4 M6 Split Washer (57)-4 M6 Flat Washer (67)-4 M10 Split Washer (46)-7 M8 Flat Washer (80)-4 M4 x 16mm Screw (64)-2 M6 x 12.7mm M6 x 16mm Button Screw (62)-4 Button Screw (68)-8 M10 x 25mm Button Screw (81)-7 M6 x 35mm Button Bolt (70)-4 1. Attach the Rear Stabilizer (8) to the Frame (1) with 1 four M10 x 25mm Button Screws (81) and four M10 Split Washers (46). 1 8 46 46 81 4