ProForm Strideselect 875 Elliptical English Manual - Page 7

4. While another person holds the Upright (2) in the position shown, connect the Upper Wire Harness (86) to the Extension Wire Harness (95). Next, insert the Upright (2) into the Mast (15); make sure that the Upright is oriented as shown. Attach the Upright with two M8 x 70mm Button Bolts (67), two M8 Split Washers (83), and two M8 Nylon Locknuts (46). Make sure that the Wire Harnesses (86, 95) do not get pinched and damaged during this step. Do not tighten the Button Bolts yet. Attach the Water Bottle Holder (72) to the Upright (2) with two M4 x 22mm Screws (76). 4 2 86 95 46 Hexagonal Holes Make sure the wire harnesses do not get pinched and damaged during this step. 72 76 83 67 83 15 5. The Console (5) requires four D batteries (not includ- 5 ed); alkaline batteries are recommended. Press the tab on the battery door and remove the battery door. Insert four batteries into the Console as shown. Make sure that the batteries are oriented as shown by the markings on the battery door. Reattach the battery door. 6. While another person holds the Console (5) near the Upright (2), connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright. Next, attach the Console to the Upright with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire harnesses. 6 5 86 66 5 Batteries Batteries Battery Cover Wire Harness Make sure the wire harnesses do not get pinched and damaged during this step. 66 2 7