ProForm Zt4 Treadmill English Manual - Page 13

11. Insert the wires into the Right Handrail (64) through the indicated hole as you set the console assembly on the Uprights (66, 76). Make sure that no wires are pinched. Attach the console assembly with ten #8 x 3/4" Screws (4). Start all ten Screws, and then tighten them. Do not overtighten the Screws. See step 5. Firmly tighten the six 3/8" x 3 1/4" Screws (2). 11 Wires Hole Console Assembly Wires 4 4 64 4 76 4 4 66 12. Orient the Latch Housing (67) so that the large hole is on the indicated side. Attach the Latch Housing to the Left Upright (66) with two #10 x 3/4" Screws (8); start both Screws, and then tighten them. Locate the Latch Pin Assembly (68). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (67). Then, tighten the knob onto the pin. 12 Knob 68 67 8 Large Hole Spring Collar Pin 13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the oor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see page 22). 13