Pyle P3001BT Instruction Manual - Page 7

Remote Control 1. Remote control should be operated within 6 meters with a scope of 30° in front of the receiver. 2. Make sure that there is no large obstacle between the remote control and the machine. 3. Remote sensor should be far away from the light, high amounts of light can a ect its performance. SAFETY INSTRUCTIONS 1. Make sure that all connections are properly connected and the main volume is set to minimum level before turning ON the unit. 2. When more than one pair of speakers are used, (specially the main speaker output) make sure that the speakers used are of the same wattage and impedance, otherwise the unit maybe damaged under high power or long term operation. 3. To avoid humming sounds and unwanted noise,make sure that all the wires are properly inserted 4. For speaker cords, strip o the vinyl coating and twist the wire tip. Push down the pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it and tighten the screw. Be careful not to let the wires stick out ofthe terminal otherwise this may cause a short circuit when wires of di erent terminal contact each other. 5. After the unit is turned ON, adjust the main volume to the desired level same with the bass and treble volume, etc. 7 www.PyleUSA.com