Pyle PA105 Instruction Manual - Page 8
Using the MIX BUS jack
View all Pyle PA105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
THE VEHICLE USING FOR THIS POWER SOURCE MUST HAVE A NEGATIVE GROUND ELECTRICAL SYSTEM. IF YOU ARE NOT SURE OF IT, PLEASE CHECK WITH YOUR VEHICLE'S DEALER. Turning the amplifier on 1.Turn on the audio input source equipment which is connected to the amplifier INPUT jack. 2.Set all volume levels (MASTER, MIC 1, MIC 2, and PHONO/AUX) to their minimum level settings. 3.Press the power switch to turn the amplifier on. 4.Adjust the controls of MIC 1, MIC 2, and PHONO/AUX to the achieve desired volume and balance. Using the LED power meter The meter LED position indicate the amplifier output power. Using the MASTER volume control The MASTER volume control increases or decreases output level gain. To obtain best performance with the least distortion, be sure to adjust the output level so that the LED meter does not continually exceed the right extreme of the meter's range. CAUTION:Setting output level too high can overdrive the amplifier, causing permanent damage. Using the MIX BUS jack You can connect another PA105/PA205 to this jack to double the size of your PA system. This lets you use up to four microphones and two turntables (or two auxiliaryies) sound souces. Use a shield cable with phono plugs at each end, and connect the cable between the MIX BUS jacks on the back of two amplifiers. For the best results, do not use a cable longer that 6 feet. Specifications Output Power at THD 10%, 1 kHz 20W (PA105)/40W (PA205) Maximum Power 80W (PA105)/120W (PA205) THD at 1W, 1 kHz Low-Pass Filter MIC 1 1% MIC 2 1% AUX/CD 1% PHONO 1% Frequency Response (at 1W, +/- 3 dB) MIC 1 80 Hz - 20 kHz MIC 2 80 Hz - 20 kHz AUX/CD 80 Hz - 20 kHz PHONO (RIAA 100 Hz/10 kHz)......+13 dB/-13.5 dB Input Sensitivity (at 10% THD, 1kHz) MIC 1 2.5 mV MIC 2 2.5 mV AUX/CD 150mV PHONO 3.5mV Signal-Noise Ratio (Input Shorted) with WTD MIC 1 60dB MIC 2 60dB AUX/CD 70dB PHONO 60dB Noise Level (Input Shorted 0.75mV Tone Control (PA105) -15dB (High Cut at 10 kHz) Equalizer Control Range (PA205) 100 Hz 10 dB 1 kHz 10 dB 8 kHz 10 dB Power Requirement 120V AC, 60 Hz/240V AC, 50 Hz 4A 12V DC (OPTION OF PA105) Power Fuse 120V AC 1.2A (PA105)/1.5A (PA205) 240V AC 0.6A (PA105)/0.75A (PA205) Dimensions H x W x D, 3 1/3 x 12 3/4 x 8 9/10(inches) 85 x 324 x 226(mm) Weight, (kg) (PA105)3.56kgs/(PA205) 3.92 kgs Mix Bus Jack 7