Pyle PD3000BA Instruction Manual - Page 14

Rear Panel Connection, Safety Instructions

Get Pyle PD3000BA PDF manuals and user guides View all Pyle PD3000BA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

REAR PANEL CONNECTION Connecting to Amplifier SAFETY INSTRUCTIONS 1. Make sure that all connections are properly connected and the main volume is set to minimum level before turning ON the unit. 2. When more then one pair of speakers are used, (specially the main speaker output) make sure that the speakers used have the same wattage and impedance, otherwise the unit maybe damaged under high power or long term operation. 3. To avoid humming sounds and unwanted noise, make sure that all the wires are properly inserted. 4. For speaker cords, strip o the vinyl coating and twist the wire tip. Push down the pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it and tighten the screw. Be careful not to let the wires stick out of the terminal otherwise this may cause a short circuit when wires of di erent terminal contact each other. 5. After the unit is turned ON, adjust the main volume to the desired level same with the bass and treble volume, etc. 13 www.PyleUSA.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
www.PyleUSA.com
13
REAR PANEL CONNECTION
Connecting to Amplifier
SAFETY INSTRUCTIONS
1. Make sure that all connections are properly connected and the main volume is
set to minimum level before turning
ON
the unit.
2. When more then one pair of speakers are used, (specially the main speaker
output) make sure that the speakers used have the same wattage and impedance,
otherwise the unit maybe damaged under high power or long term operation.
3. To avoid humming sounds and unwanted noise, make sure that all the wires are
properly inserted.
4. For speaker cords, strip off the vinyl coating and twist the wire tip. Push down the
pink jack or loosen the screw terminal, before inserting the wire tip, then fasten it
and tighten the screw. Be careful not to let the wires stick out of the terminal
otherwise this may cause a short circuit when wires of different terminal contact
each other.
5. After the unit is turned
ON
, adjust the main volume to the desired level same
with the bass and treble volume, etc.