RCA 25450RE3 User Guide - Page 17
Installing the Charging Cradle Wall Mount, Registering the Cordless Handset
UPC - 044319501155
View all RCA 25450RE3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Leave 3" from here to plug Insert tabs here Cord Channel Mounting Surface 3/16" Loop inside to prevent pinching Connections and Setup Installing the Charging Cradle Wall Mount Choose a mounting location at least 10-1/2" clearance above the top screw hole. 1. Cut out the Charging Cradle Wall Mount Template. See page 121. 2. Hold the template against the wall and mark the mounting screw positions. 3. Drill holes in wall using appropriate size drill bit. 4. Insert anchor screws into the wall. We recommend #8 pan head screws. Allow 3/16" space between screw heads and wall. 5. Press the AC adapter cord in the cord channel of the wall bracket. Allow approximately 3" of cord past the end of the channel. 6. Insert the round connector on the AC adapter cord into the connection on the bottom of the charging cradle. 7. Insert the front tabs of the bracket in the square holes of the charging cradle. Swing the cradle down to snap it in place. Make sure the AC adapter cord is not pinched between the cradle and the mount. 8. Mount the assembly to the wall. 9. Plug the AC Adapter into a power outlet. 10. Insert the cordless handset into the cradle. Charge the battery for 12 hours before the first use. Registering the Cordless Handset Cordless Handsets purchased separately must be registered with the Base Unit before using. If the Cordless Handset was purchased with the Base Unit as a system, it has already been registered. Refer to the Settings and Adjustments section in this User's Guide for instructions on registration. 17