RCA RCR311S User Guide - Page 10
Rcr311s_na_ib_revb_k4.qxd, 27/04, 41 Am, - remote codes
View all RCA RCR311S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
RCR311S_NA_IB_REVB_K4.qxd 7/27/04 11:41 AM Page 10 Programming Methods (continued) VCR•DVD ON•OFF VCR•DVD (BLINK) VCR•DVD ON•OFF (BLINK) 4. VCR•DVD TV SAT•CBL ON•OFF 5. (BLINK) ON•OFF 6. 7. a. Press and hold the VCR•DVD key. The illuminated ON•OFF key turns on. b. While holding down the VCR•DVD key, press and release the number 2 key on the keypad to control a VCR or the number 3 key to control a DVD. The illuminated ON•OFF key turns off. c. Release the VCR•DVD key. The illuminated ON•OFF key blinks four times and then turns off. Your remote is now either in VCR or DVD Programming Mode, depending on which you chose. Proceed to step 4. Press and hold the component key (TV, VCR•DVD, SAT•CBL) you wish to program. The illuminated ON•OFF key turns on and remains on. While holding the component key down, press and hold the ON•OFF key. The illuminated ON•OFF key turns off. After holding down both keys for three seconds, the illuminated ON•OFF key turns back on. Release both keys. The illuminated ON•OFF key remains on. ! TIP: Throughout the programming of each key, be sure to keep the remote pointed at the IR sensor of the component you are currently programming the remote to control. PLAY ON•OFF (BLINK) REVERSE ON•OFF (BLINK) 8. Press and release the PLAY key, then wait five seconds to see if your component turns off. If your component does not respond, continue to press the PLAY key every five seconds until your component turns off. Each time you press the PLAY key, the illuminated ON•OFF key blinks and a block of 10 codes are sent to your component. This process continues until all of the codes in the Code Lists have been searched. (If your component has not turned off after all codes have been searched, the illuminated ON•OFF key blinks four times and turns off. The Auto Code Search Entry method is exited.) 9. When your component turns off, you know the correct code is in the last block of 10 codes sent. Press and release the REVERSE key. Wait two seconds to see if your component turns on again. If your component does not respond, continue to press the REVERSE key every two seconds until your component turns on again. This will isolate the correct code in the last block of codes sent. Each time 10