Reebok 1210 Elliptical English Manual - Page 10
Insert the Pivot Axle 35 through the Upright 4
View all Reebok 1210 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
6. See the inset drawing. Locate the wire tie in the lower end of the Upright (4). Tie the wire tie to the Main Wire (111). Then, pull the upper end of the wire tie until the Main Wire is routed through the Upright. Tip: To prevent the Main Wire (111) from falling into the Upright (4), secure the Main Wire with the wire tie. 6 111 Wire Tie Wire Tie 111 4 111 7. Using a plastic bag to keep your fingers clean, apply some of the included grease to the Pivot Axle (35) and to two 16mm Wave Washers (54). Insert the Pivot Axle (35) through the Upright (4) and center it. Tip: It may be helpful to use a rubber mallet. Identify the Right Upper Body Leg (60) and orient it as shown. Slide a 16mm Wave Washer (54) and the Right Upper Body Leg (60) onto the right side of the Pivot Axle (35). Repeat these actions for the Left Upper Body Leg (46). Tighten an M8 x 13mm Screw (82) and an M8 Washer (97) into each end of the Pivot Axle (35) at the same time. 7 46 4 35 Grease 54 60 97 82 10