Rheem RARL-JEC Installation Instructions - Page 7

2.5 PROPER INSTALLATION Proper sizing and installation of this equipment is critical to achieve optimal performance. Use the information in this Installation Instruction Manual and reference the applicable Engineering Specification Sheet when installing this product. IMPORTANT: This product has been designed and manufactured to meet ENERGY STAR® criteria for energy efficiency when matched with appropriate coil components. However, proper refrigerant charge and proper airflow are critical to achieve rated capacity and efficiency. Installation of this product should follow the manufacturer's refrigerant charging and airflow instructions. Failure to confirm proper charge and airflow may reduce energy efficiency and shorten equipment life. 3.0 LOCATING UNIT 3.1 Corrosive Environment The metal parts of this unit may be subject to rust or deterioration if exposed to a corrosive environment. This oxidation could shorten the equipment's useful life. Corrosive elements include, but are not limited to, salt spray, fog or mist in seacoast areas, sulphur or chlorine from lawn watering systems, and various chemical contaminants from industries such as paper mills and petroleum refineries. If the unit is to be installed in an area where contaminants are likely to be a problem, special attention should be given to the equipment location and exposure. • Avoid having lawn sprinkler heads spray directly on the unit cabinet. • In coastal areas, locate the unit on the side of the building away from the water- front. • Shielding provided by a fence or shrubs may give some protection, but cannot violate minimum airflow and service access clearances. • Elevating the unit off its slab or base enough to allow air circulation will help avoid holding water against the basepan. Regular maintenance will reduce the build-up of contaminants and help to protect the unit's finish. ! WARNING DISCONNECT ALL POWER TO UNIT BEFORE STARTING MAINTENANCE. FAILURE TO DO SO CAN CAUSE ELECTRICAL SHOCK RESULTING IN SEVERE PERSONAL INJURY OR DEATH. • Frequent washing of the cabinet, fan blade and coil with fresh water will remove most of the salt or other contaminants that build up on the unit. • Regular cleaning and waxing of the cabinet with a good automobile polish will provide some protection. • A good liquid cleaner may be used several times a year to remove matter that will not wash off with water. Several different types of protective coatings are offered in some areas. These coatings may provide some benefit, but the effectiveness of such coating materials cannot be verified by the equipment manufacturer. 3.2 CONDENSER LOCATION Consult local and national building codes and ordinances for special installation requirements. Following location information will provide longer life and simplified servicing of the outdoor condenser. NOTE: These units must be installed outdoors. No ductwork can be attached, or other modifications made, to the discharge grille. Modifications will affect performance or operation. 7