Ricoh 9100DN Software User Guide - Page 203
ifconfig, View settings, IPv4 Configuration, Netmask configuration, Broadcast address configuration
UPC - 026649026164
View all Ricoh 9100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Remote Maintenance by telnet ifconfig Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address, default gateway address) for the printer. View settings msh> ifconfig IPv4 Configuration msh> ifconfig "interface_name" "parameter" "address" • If you did not enter an interface name, it is automatically set to the Ethernet interface. • wlan can be specified only when the IEEE 802.11b interface unit is installed. Interface name Interface configured ether Ethernet Interface 5 wlan IEEE 802.11b Interface The following explains how to configure an IPv4 address 192.168.15.16 on Ethernet interface. msh> ifconfig ether 192.168.15.16 IPv6 Configuration msh> ifconfig ether inet6 "interface_name" "prefixlen" The following explains how to configure a IPv6 address to 2001:DB8::100 with prefix length 64 on the Ethernet interface. msh> ifconfig ether inet6 2001:DB8::100 64 Netmask configuration msh> ifconfig "interface_name" netmask "address" The following explains how to configure a subnet mask 255.255.255.0 on Ethernet interface. msh> ifconfig ether netmask 255.255.255.0 Broadcast address configuration msh> ifconfig "interface_name" broadcast "address" Changing the Interface msh> ifconfig "interface" up You can specify either the Ethernet interface or IEEE 802.11b interface when using the optional IEEE 802.11b interface unit is installed. • To get the above addresses, contact your administrator. • Use the default configuration if you cannot obtain setting addresses. 201