Ricoh Aficio MP 8001 Operating Instructions - Page 89
In [System Settings], under [Interface
View all Ricoh Aficio MP 8001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
When You Cannot Print When You Cannot Print This section describes what to do if printing does not start even after performing [Print]. Problem Printing does not start. Printing does not start. Printing does not start. Printing does not start. Printing does not start. Printing does not start. Printing does not start. Cause Solution The power is off. Check the cable is securely plugged into the power outlet and the machine. Turn on the main power switch. The machine is set to Press [ Online]. "Offline". The cause is displayed on the Check the error message or warning 4 display of the control panel. status on the display panel and take the required action. The interface cable is not connected correctly. Connect the interface cable securely. If it has a fastener, fasten that securely as well. See "Connecting to the Interfaces", Network and System Settings Guide . The correct interface cable is not being used. The type of interface cable you should use depends on the computer. Be sure to use the correct one. If the cable is damaged or worn, replace it. See "Connecting to the Interfaces", Network and System Settings Guide . The interface cable was connected after the machine was switched on. Connect the interface cable before turning on the machine. If the machine is using wireless LAN, failure to print might result from a weak wireless signal. In [System Settings], under [Interface Settings], select [Wireless LAN], and then press [Wireless LAN Signal] to check signal status. If signal quality is poor, move the machine to a location where radio waves can pass or remove objects that might cause interference. (You can check signal status only when using wireless LAN in the infrastructure mode.) 87