Ricoh C220S User Guide - Page 247
Error and Status Messages on the Screen
UPC - 026649061264
View all Ricoh C220S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
Error and Status Messages on the Screen Error and Status Messages on the Screen This section describes the meaning of messages that appear on the screen and what to do when a particular message appears. Messages are listed in alphabetical order in the table below. "X" indicates the parts of the messages that appear differently depending on a specific situation, such as the paper sizes or types, tray names, or toner colors. Message Causes Solutions ADF JAM Open ADF Cover and Clear Jam An original has been jammed inside the ADF. • Remove jammed originals, and then place them again. See p.228 "Removing Scanning Jams". • Check the originals are suitable for scanning. See p.87 "Placing Originals". ADF Kit Life Replace ADF Kit The ADF kit needs to be replaced. Replace the ADF kit. Contact your sales or service representative. Application Disable Press Clear Key The requested scan feature Enable the Scan to E-mail, has been disabled by the user. Scan to FTP or Scan to Folder feature. Access the machine using a Web browser, click [Network Application], and then select the relevant checkbox. Bypass Tray not supported by You selected duplex printing Select a different tray. duplex using paper fed from the by- pass tray, but the bypass tray does not support duplex printing. 9 Bypass Tray Paper Empty The bypass tray has run out of Load paper to the bypass tray. paper. See p.80 "Loading Paper in the Bypass Tray". Bypass Tray Paper Size Mismatch?Y/N The paper size set for the document differs from the size of the paper in the tray. Press the {B&W Start} key or {Color Start} key to begin printing, or press the {Clear/Stop} key to cancel the job. Bypass Tray Paper Type Mismatch?Y/N The paper type set for the doc- Press the {B&W Start} key or ument differs from the type of {Color Start} key to begin the paper in the tray. printing, or press the {Clear/Stop} key to cancel the job. Calibrating... The machine is calibrating the Wait a while. color. 239