Ricoh Pro 8110s User Guide - Page 207
When documents cannot be stored on a memory storage device, WSD Scanner. Time outs occur
View all Ricoh Pro 8110s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
Messages Displayed When Using the Scanner Function Messages "Could not send the data because the PC timed out before it was sent." Causes A time out occurred when using WSD Scanner. Time outs occur when too much time passes between scanning an original and sending its data. The followings are likely causes of time outs: • Too many originals per set. • Misfed originals. • Transmission of other jobs. Solutions • Reduce the number of originals, and then scan again. • Remove any misfed original, and then scan again. • Use Scanner Journal to check there are no jobs awaiting transmission, and then scan again. When documents cannot be stored on a memory storage device Messages "Cannot write on the memory storage device because remaining free space is insufficient." "Cannot write on the memory storage device because the device is write-protected." Causes Solutions • The memory storage device is full and scan data cannot be saved. • Even if the memory storage device appears to have sufficient free space, data might not be saved if the maximum number of files that can be saved is exceeded. • Replace the memory storage device. • If the document is scanned as single-page or divided multiple pages, data already written to the memory storage device is saved as is. Replace the memory storage device, and then press [Retry] to save the remaining data, or press [Cancel] to redo the scan. The memory storage device is write-protected. Unlock the write-protection on the memory storage device. 199