Ryobi ACTIL04 Operation Manual - Page 1
Ryobi ACTIL04 Manual
![]() |
View all Ryobi ACTIL04 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
ACTIL04 REPLACEMENT TINES FOR USE WITH RY40703 RYOBI 40 VOLT FRONT TINE TILLER WARNING: To reduce the risk of injury, user must read and understand the operator's manual for their cultivator before using this accessory. Save these instructions. Refer to them frequently and use them to instruct other users. If you loan someone this product, loan them these instructions also. WARNING: Ensure compatibility and fit before using this accessory. Do not use this accessory if a part is damaged or missing. If you are not comfortable performing any of the functions described in these instructions, take your unit to a qualified service center. Fig. 1 C A C B F C C D B E E E E A - Left outer tine assembly (assemblage de dent extérieure gauche « A », conjunto de púas exterior izquierda "A") B - Tine shaft (arbre de dents, eje de las púas) C - Shear pin (goupille de sécurité, pasadore de seguridad) D - Right outer tine assembly (assemblage de dent extérieure droite, conjunto de púas exterior derecho) E - Cotter pin (goupille fendue, clavija) F - Gear box (boîte de transmission, caja de engranajes) WARNING: Always protect hands by wearing heavy gloves and/or wrapping the cutting edges of the tines with rags and other material when installing or removing tines. Contact with the tines could result in serious personal injury. REMOVING AND REPLACING THE TINES See Figures 1 - 2. With user facing the front of the tiller, the left outer tine assembly is marked "A". The left inner tine assembly is marked "B". The right inner tine is marked "C" and the right outer tine is marked "D". For correct operation of the unit, the tines must be installed in the correct position. Remove the protective caps from tines. Insert shear pins through the holes in the tine shaft closest to the gear box. Secure with cotter pins. Place the inner tine assemblies marked "B" and "C" on the tine shaft as shown. Align the notches of the inner tine assemblies with the heads of the shear pins. NOTE: You may have to rotate the tine assemblies until the holes in the assemblies are aligned with the holes in the tine shaft. If the holes do not align, the tine assemblies may be installed on the wrong sides. Reverse the position of the tine assemblies and check for hole alignment. When installed correctly, the "C" on the right inner tine assembly should be closer to the gear box than the "B" on the left inner tine assembly. Insert shear pins through the holes in the inner tine assemblies and the shaft. Secure with cotter pins. Fig. 2 C A B F C D B E E A - Left outer tine assembly (assemblage de dent extérieure gauche, conjunto de púas exterior izquierdo) B - Tine shaft (arbre de dents, eje de las púas) C - Shear pin (goupille de sécurité, pasadore de seguridad) D - Right outer tine assembly (right assemblage de dent extérieure droite « D », conjunto de púas exterior derecho "D") E - Cotter pin (goupille fendue, clavija) F - Gear box (boîte de transmission, caja de engranajes) Place the outer tine marked "D" on the right side of the tine shaft and the outer tine marked "A" on the left side of the shaft. Rotate the outer tines until the holes in the tines are aligned with the holes in the tine shaft. Insert shear pins through the holes in the outer tine assemblies and the shaft. Secure with cotter pins.
![](/manual_guide/products/ryobi-actil04-operation-manual-ce7ab85/1.png)