Ryobi AG452K English Manual - Page 9

ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included. n Inspect the tool carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. n If any parts are damaged or missing, please call 1-800-525-2579 for assistance. PACKING LIST Angle Grinder Wrench Disc Flange Flange Nut Side Handle Grinding Wheel Wire Wheel Abrasive Mop Disc Case Operator's Manual WARNING: If any parts are damaged or missing do not operate this tool until the parts are replaced. Failure to heed this warning could result in serious personal injury. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. TO LOOSEN side Handle WARNING: Thoroughly inspect a new grinding wheel before you install it on the grinder. •Tap lightly around the wheel using a wooden hammer. •Listen carefully to the resulting sounds. Places with fissures or cracks will result in a different sound. Do not use a wheel containing fissures or cracks. When you install a new grinding wheel, carry out a no load revolution test of approximately one minute with the grinding wheel facing a safe direction, i.e., away from people or objects. WARNING: The side handle must always be used to help prevent loss of control and possible serious injury. TO TIGHTEN Fig. 2 WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. installing THE Side handle See Figure 2.  Unplug the angle grinder.  Insert the side handle into the desired operating position.  Securely tighten by turning the side handle clockwise. NOTE: The handle can be installed on the top, left, or right side of the grinder, depending on operator preference.