Ryobi CSB133L English Manual - Page 11
Assembly
View all Ryobi CSB133L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ASSEMBLY ATTACHING BLADE See Figures 2 - 4. n Unplug the saw. n Depress and hold spindle lock button. n Remove blade screw by turning it counterclockwise with the blade wrench, while keeping the spindle lock button depressed. n Remove spring washer and outer blade washer ("D" washer). n Wipe a drop of oil onto the inner flange bushing and outer blade washer ("D" washer) where they contact blade. WARNING: If inner flange bushing has been removed, replace it before placing blade on spindle. Failure to do so will prevent blade from tightening properly and could result in serious personal injury. n Retract the lower blade guard into the upper blade guard using the lower blade guard handle. Make sure the lower guard spring works properly, allowing the guard to move freely. n Check to see that the saw teeth and arrow on the saw blade and the arrow on the upper guard are pointing in the same direction. NOTE: The saw teeth point upward at the front of the saw as shown. n Fit the saw blade inside the lower blade guard and onto the spindle. n Replace "D" washer. n Replace spring washer with cupped side against "D" washer. n Depress spindle lock button and replace blade screw. n Tighten blade screw securely by turning it clockwise with the blade wrench. NOTE: Never use a blade that is too thick to allow the "D" washer to engage with the flat on the spindle. REMOVING BLADE See Figures 2 - 4. Unplug the saw. Depress and hold spindle lock button. Remove blade screw by turning it counterclockwise with the blade wrench, while keeping the spindle lock button depressed. Remove spring washer and outer blade washer ("D" washer). Lift lower blade guard. Remove blade. 11 SPINDLE lock button arrow on UPPER guard TO LOOSEN BLADE GUARD HANDLE TO TIGHTEN blade wrench Fig. 2 SPINDLE OUTER bladE WASHER ("D" WASHER) INNER FLANGE BUSHING BLADE OUTER BLADE WASHER ("D" WASHER) SPRING WASHER BLADE SCREW Fig. 3 CUPPED SIDE OF OUTSIDE OF SPRING WASHER SPRING WASHER Fig. 4