Ryobi CSB133L English Manual - Page 15

OPERATION USING THE LASER GUIDES See Figure 12. WARNING: Do not stare into the laser beams or turn the lasers on when the tool is not in use. Failure to heed this warning could result in possible serious personal injury. The laser guide will generate a red laser beam on the work surface in front of the saw when turned on. The laser aids in following the line of cut when cutting the workpiece. NOTE: The laser unit comes from the factory already installed and aligned. If the laser becomes misaligned after time, refer to the Adjustments section later in this manual.  Unplug the saw.  Mark the line to be cut on the workpiece.  Adjust the depth and angle of the cut as needed.  Plug the tool into a power supply and press the laser guide button to activate the laser.  Start the motor. NOTE: Do not touch the blade to the workpiece until the saw has reached maximum speed.  Slowly push the saw forward into the workpiece. NOTE: Keep the laser beam on the marked line on the workpiece for precision cutting.  Once the cut is complete, allow the saw to come to a complete stop before turning off the laser. laser guide BUTTON laser guide BEAM 45 push in TURN ON push in TURN OFF 51.5 30 15 Fig. 12 15