Ryobi JM82K English Manual - Page 23

MAINTENANCE n Using a screwdriver, remove the two screws that connect the front and rear base assemblies. n Carefully separate the front base assembly from the rear base assembly. Remove the front base assembly. NOTE: These pieces are tightly joined. It may be helpful to use a mallet to lightly tap the area where the assemblies meet. n Remove the rear base assembly. n With the assemblies separated, clean wood particles and resin from the blade area, dust bag port, front and rear assemblies and all surrounding areas. n Apply a thin coat of general purpose grease in slots or tracks on the bearing plate where the base slides. n Replace the rear base assembly. n Replace the front base assembly. Replace and tighten the screws that connect the front and rear base assemblies. n Replace the springs. n Reinstall or replace the blade. n Secure the shoe with the washers and screws. n Replace the dust bag. CLEANING THE DUST BAG See Figure 28. n Unplug the biscuit joiner. n Remove the dust bag. n Slide the clip off the end of the dust bag. n Thoroughly clean the dust bag by shaking out all debris. n Replace the clip. n Replace the dust bag. TRACK(S) FRONT BASE ASSEMBLY SLOT(S) SCREWS REAR BASE ASSEMBLY Fig. 27 Fig. 28 23