Ryobi P212 English Manual - Page 14
Two-speed Gear Train, Caution, Quick Mode Selector, Selecting Drive Or Drill Setting - power tools
View all Ryobi P212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
OPERATION TWO-SPEED GEAR TRAIN See Figure 7. The drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of the drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed for fast drilling or driving applications. NOTE: If you have difficulty changing from one gear range to the other, turn the chuck by hand until the gears engage. CAUTION: Never change gears while the tool is running. Failure to obey this caution could result in serious damage to the drill. QUICK MODE SELECTOR See Figure 8. The Quick Mode Selector allows you to quickly switch from drill mode to drive mode. In general, drill mode should be used for drilling and other heavy duty applications. Drive mode should be used for driving screws. Hammer mode should be used for hammer drilling. SELECTING DRIVE OR DRILL SETTING See Figure 9. Using the chart on the next page, select the option that best matches the type of bit, fastener, and material you will be using. 1. CHOOSE YOUR APPLICATION 2. CHOOSE THE CORRECT SPEED (1/LOW or 2/HIGH) 3. CHOOSE THE CORRECT MODE (DRIVE, DRILL, OR HAMMER) TWO-SPEED GEAR TRAIN (HI-LO) 1 2 HIGH SPEED LOW SPEED DRIVE MODE Fig. 7 DRILL MODE (TORQUE ADJUSTMENT HAMMER NOT ACTIVE) MODE Fig. 8 2 3 QUICK MODE SELECTOR Fig. 9 14