Samsung DV9100 User Manual - Page 29

02 operating instructions, tips Level Message Status 0 The "Vent Sensor " The ductwork is free from lamp is turned off. blockages. - Solution 1 The "Vent Sensor lamp illuminates. " When a part of the duct or the lint filter is blocked by lint or a foreign object. Check the duct connection and shorten the duct and straighten it if necessary. When the resistance is high because the duct is too long or bent. Check the lint filter or the duct and clean it if necessary. Check the duct When the duct is blocked by connection and shorten lint or a foreign object. the duct and straighten it 2 The "Vent Sensor lamp blinks. " When the resistance is very if necessary. high because the duct is too Check the lint filter or the long or bent excessively. duct and clean it as soon as possible. In the LEVEL 2 state, this lamp blinks for 3 hours after the completion of the cycle. (If the wrinkle prevention function is activated, this message is displayed for up to 3 hours.) If the power button is pressed or the door is opened, the power is immediately turned off. For more information about the duct installation, please refer to the "Ducting requirements" section on page 8. • Although the dryer is available even if the blockage message is displayed, the drying time may be extended. • If the LEVEL 1 message is displayed the first time the dryer is run after the installation, check the connection and clean the duct. If the LEVEL 1 message appears even after you have checked and cleaned the ducts, this may indicate that there are some restrictions of the duct due to the length, condition, etc. If this occurs, you can use the dryer normally and no countermeasures need to be taken. However, the drying time may be extended or the drying performance may be degraded. English - 29 %7)"
%3:@%7)@64&3
."/6 JOEE