Samsung LN40A750R1F User Manual (ENGLISH) - Page 107

Network Settings and InfoLink To access Samsung's Infolink network feature, you must make one of the connections on the following pages. Network Connection - Cable LAN Connection for a DHCP Environment The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them manually. The Modem Port on the Wall External Modem (ADSL/VDSL/Cable TV) LAN 1 Cable 2 Modem Cable TV Rear Panel 1. Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable. 2. Connect the LAN port on the wall and the external modem with a Modem Cable. You can connect the LAN via a Sharer (Router). IP Sharer The Modem Port on the Wall External Modem (ADSL/VDSL/ Cable TV) LAN Cable LAN Cable TV Rear Panel Modem Cable You can connect the LAN port and the TV directly depending on your network status. The LAN Port on the Wall TV Rear Panel LAN Cable ➣ The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer. ➣ If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10 seconds and then try again. ➣ For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the corresponding product. ➣ You can connect the TV to the LAN directly without connecting it through a Sharer (Router) ➣ You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automatic-connection-type ADSL modem. English - 105