Samsung ME21M706BAS/AA Installation Guide - Page 5
Exhaust connection, Maximum duct length, Elbows, transitions, wall and roof, caps, etc.
View all Samsung ME21M706BAS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
General information NOTE: If you need to install ducts, note that the total duct length of 3 ¼˝ x 10˝ rectangular or 6˝ diameter round duct should not exceed 140 equivalent feet. Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully. NOTE: It is important that venting be installed using the most direct route and with as few elbows as possible. This ensures clear venting of exhaust and helps prevent blockages. Also, make sure dampers swing freely and nothing is blocking the ducts. Exhaust connection: The hood exhaust has been designed to mate with a standard 3 ¼˝ x 10˝ rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6˝ diameter duct. Maximum duct length: For satisfactory air movement, the total duct length of 3 ¼˝ x 10˝ rectangular or 6˝ diameter round duct should not exceed 140 equivalent feet. Elbows, transitions, wall and roof caps, etc. present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent lengths of all transitions and adaptors plus the length of all straight duct sections. The chart below shows you how to calculate total equivalent ductwork length using the equivalent length in feet of some typical ducts. DUCT PIECES Rectangular-to-Round Transition Adaptor* EQUIVALENT LENGTH 5 ft. x NUMBER USED = EQUIVALENT LENGTH x ( ) = ft. Wall Cap 40 ft. x ( ) = ft. 90 ° Elbow 10 ft. x ( ) = ft. 45 ° Elbow 5 ft. x ( ) = ft. 90 ° Elbow 25 ft. x ( ) = ft. 45 ° Elbow 5 ft. x ( ) = ft. Roof Cap 24 ft. x ( ) = ft. Straight Duct 6˝ Round or 3 ¼˝ x 10˝ Rectangular 1 ft. x ( ) = ft. Total Ductwork = ft. * IMPORTANT: If a rectangular-to-round transition adaptor is used, the bottom corners of the damper will have to be cut to fit, using tin snips, to allow free movement of the damper. Equivalent lengths of duct pieces are based on actual tests and reflect the requirements for good venting performance with any vent hood. 5 SMH1927_XAA_DE68-04108A-05_EN.indd 5 6/19/2019 6:12:09 PM